Dave von Hollen Co-author: Steve Newton, BeauTech Inc.
In order to produce available fluids, pump jacks used at surface have been engineered to stroke as slow as 6 (six) strokes per minute (SPM) and as fast as 14 (fourteen) SPM. Depending on available production, pump length (.stroke) and pump size were the only two other variables taken into consideration. This approach works well until a time is reached when production has declined to a point where production inflow no longer matches pump capacity. As production declined, the typical method of compensation was to shorten the stroke, downsize the pump and remain at a constant SPM somewhere around 10 (ten) SPM. As production declines this approach eventually results in partial pump fill even with small bore pumps, short stoke and slowing the unit as much as possible with current sheave limitation. At this point it is physically impossible to fit a large enough sheave on the gear box or small enough sheave on the electric motor to reduce the speed below approximately 6 (six) SPM.