COST-EFFECTIVE APPLICATION OF 50:50 POZ CEMENTING AND ENHANCED PROPERTIES IMPROVEMENTS
Admixtures of 50:50 Class H (or Class C): Pozzalon with 2% bentonite have functioned effectively worldwide for almost 50 years as lightweight slurries, for situations where heavier completion cements posed a risk of exceeding low fracture gradients in a particular wellbore. Pozzolanic materials are lightweight, and effectively combine with calcium hydroxide that is liberated during the hydration of portland cement. But there have been two disadvantages to the 2% bentonite utilized to assist in the specification of relatively high water-to cement ratios: First, its presence in typical cement slurries reduces the effectiveness of a given concentration of most commercially available fluid loss additives. Second, while the 2% (by weight of cement) volume may seem of no consequence, the shipping costs associated with moving tons of the material over a long period of time can be significant. Extensive testing of 50:50 slurries revealed that small quantities of sodium metasilicate (on the order of 0.5% by weight of cement) could effectively replace bentonite. Free water was controlled to the same degree, and a synergy with a commonly available fluid loss additive was discovered, allowing either a) less total fluid loss additive for a given fluid loss control tolerance, or, b) better fluid loss control for a given concentration of fluid loss additive. This project was undertaken to determine whether or not there were other commercially available materials that could substitute for bentonite