Vithal Pai, The Western Company
In order to combat falling productivity and increased water production in the West Flowers and Guest (Canyon Sand) fields, a new approach to stimulation technique and fluid had to be initiated. It was suspected that many pre-1975 frac jobs probably were lost into unproductive zones resulting in very little stimulation of the actual pay section. To combat this situation, the frac fluid was changed to a very high viscosity cross-linked CM C-based polymer gel. The base fluid was 2% KC1 water treated with de-emulsifiers. A detailed computerized study was conducted to determine a near optimum treatment design. Fluid volumes were selected based on frac lengths which provided the most economically feasible productivity increase ratios (J/Jo) and proppant concentrations were analyzed so as to afford the optimum permeability contrasts. Sand concentrations were increased, and 10-20 mesh sand was used. The perforations are acidized and broken down. This is followed by a base temperature survey. A 2,000-gal dummy stage (slick water) is pumped to determine the zone taking fluid. If channeling is observed, a stage of a calculated amount of benzoic acid flakes is run to divert thef2uid into the pay section. A 2,000-gal dummy stage is next pumped. Based on the results of a temperature and radioactive survey, the fraction of the pay section taking fluid is determined. A proportional amount of frac is pumped followed by a calculated amount of block. This is followed by a shut-in period of 20 minutes to let the fracture heal and the surface pressure till about 500 psi. The above steps are repeated until all or most of the zone is fractured.